Available HERADESIGN® product range:
Recommended panel thickness: 25 mm for ceilings, 35 mm for walls (exception: Product range A2)
All available products can be found in our product finder
Available HERADESIGN® product range A2:
All available products can be found in our product finder
Available HERADESIGN® product range:
Recommended panel thickness: 25 mm for ceilings, 35 mm for walls (exception: Product range A2)
All available products can be found in our product finder
Mark out the ceiling module from the centre of the room, for example using a chalk line. Ensure the margins at the sides of the room are identical.
Align the laths using a spirit level or laser level and fix the laths to the hangers, e.g. quick hangers, using 2 screws per side.
Install the main laths and cross supports. Maximum centres according to the “Maximum centres of grid structure” table for screw-fixing onto wooden laths and the main laths/cross laths connection detail, page 14.
Install the acoustic tiles with the aid of a support. When fixing, press the tile onto the lath using the heel of your hand. There must be no gap between the tile and the wooden lath. For large ceiling areas, begin tile installation from the centre of the room. Observe the installation direction of square tiles!
Align the rows of tiles with an installation lath. Tile joints must be positioned centrally under the laths. No free tile joints are allowed.
Close possible gaps between the tiles using a wooden block and hammer. Only handle the acoustic tiles with clean hands (clean gloves are recommended) and clean tools.
Insert HERADESIGN® acoustic over-lays or other acoustic over-lays, step-by-step when installing the HERADESIGN® acoustic tiles. Absorber tiles that are pushed between the wooden laths are cut to size.
If coloured screws are not used, paint over the screw heads with the paint supplied or a suitable equivalent using a fine brush and suitable amount of paint. Screw heads must be flush with the tile surface.
Mark out the ceiling module from the centre of the room, for example using a chalk line. Ensure the margins at the sides of the room are identical.
Align the CD-profiles using a spirit level or laser level.
Aligning the CD profiles using a spirit level or a laser device.
Finished ceiling grid
Install the acoustic tiles with the aid of a support. When fixing, press the tile onto the profile using the heel of your hand. There must be no gap between the tile and the profile. Begin tile installation from the centre of the room. Only handle the acoustic tiles with clean hands (clean gloves are recommended) and clean tools.
Align the rows of tiles with an installation lath. Tile joints must be positioned centrally under the profiles. No free tile joints are allowed! When installing square tiles, observe the installation direction marked on the back of the tiles.
Insert HERADESIGN® acoustic over-lays or other acoustic over-lays, step-by-step when installing the HERADESIGN® acoustic tiles. Absorber tiles that are pushed between the CD-profiles are cut to size.
If coloured screws are not used, paint over the screw heads with the paint supplied or a suitable equivalent using a fine brush and suitable amount of paint. Screw heads must be flush with the tile surface.
